Titulní stránka    Podpora    Kontakt     

Get Moving.

Segway i2 Specs
Segway i2 specifications

The Segway® Personal Transporter (PT) i2 is our most versatile model, and is available with either a gloss white or anodized black handlebar. Learn more about the i2.

Detailní specifikace (anglicky):


Top speed and turning rate

The maximum forward speed and turning rate of your Segway i2 can be set using the wireless InfoKey controller. The two settings are
  • Beginner Mode
    Maximální rychlost: 6 mph / 9.6 km/h
    Slower turning rate

  • Regular Mode
    Maximální rychlost: 12.5 mph / 20 km/h
    Most responsive turning rate


16-24 miles / 24-39 km on a single charge
podle terénu a stylu jízdy

Operating range

14º to 122º F
/-10º to 50º C

When stored and charged at room temperature, the i2 can perform in a wide range of operating environments. Actual performance is dependent on battery temperature, terrain, riding style and payload.


The i2’s large tires and track width make it suitable for a wide range of applications and terrains. Its sensors constantly monitor the rider's position relative to gravity. This allows the Segway i2 to adjust for changes in terrain while keeping the rider upright.


Total capacity (rider & cargo): 260 lbs / 118 kg
Rider: 100-250 lbs / 45-110 kg

The Segway i2 can carry up to a 250 lb. adult. It can also be fitted with optional Segway Cargo Accessories for a total capacity of 260 lbs.


Výška plošiny: 8 in / 21 cm
Rozvor: 19 x 25 in / 48.3 x 63.5 cm
Ground Clearance: 3 in / 7.6 cm

We designed the Segway i2 to take up no more space than the average person. About as wide as the average person's shoulders, it raises you 8 inches off the ground, providing a clear sight line of your surroundings.


105 lbs / 47 kg
Portability was a key design objective. That's why we made the Segway i2 light enough to handle, small enough to store in the trunk of a midsize sedan, and collapsible enough to fit in tight storage spaces. Optional lower cargo frames provide east-to-grip handles for storage and transport.

Turning radius

One characteristic of a pedestrian is the ability to turn in place without impacting any nearby person or object, something few vehicles can do. By balancing on a single axle, Segway i2 riders can also turn in place.


Lithium-ion (Li-ion) Battery Packs

The i2 comes with Saphion lithium-ion battery packs. The batteries are designed with on-board electronics that automatically monitor both the condition and temperature of the batteries. Batteries can be recharged by utilizing any 90 to 260 volt and 50 to 60 Hz AC outlet (typically accessible in most countries). A complete cycle charge will take eight to ten hours, which at 10 cents per KW-h, equates to about the cost of a newspaper. Li-ion batteries are designed for approximately1000 full charge/discharge cycles.


Redundant electrical systems
Robust mechanical systems

Safety is our top priority in both design and operation. To help ensure that both Segway PT users and those near them remain safe, we built redundancy into the balancing and electrical systems. If any system begins operating at diminished capacity, the other is programmed to assume responsibility. This allows the Segway PT to maintain balance and bring the rider to a safe stop. We implemented the highest design standards in building the Segway PT's mechanical structures, and each part has been thoroughly tested and analyzed to ensure such high standards were met. Millions of fatigue cycles and thousands of hours of ride testing were completed in the development of the Segway PT.